NEW...NEW...NEW...
Gutter Clean System
 

 
DESCRIPTION
The eaves troughs are molded on site without joints. They may be adapted to all types of roofs and are anchored to all types of structures. Higher back edges prevent the water back-ups.

Installation
5" Eavestrough
Mainly installed with wood structures and anchored with twisted nails at 300 mm (12") c/c Roof surface drainage capacity of up to 75 m2 (800 pi.ca), ** Connected to 50 X 75 mm (2" X 3") aluminum downspout
 
COMMERCIAL6" Eavestrough
Recommended with all types of structures and metal roofs it is anchored to the fascia with appropriate fastener at 300 mm (12") c/c. Roof surface drainage capacity of up to 280 m2 (300 pi.ca).** Connected to 75 X 100 mm (3" X 4") aluminum downspout.

DOWNSPOUTS

Regular
2 ½ inch X 3 ½ inch
Commercial
3 inch x 3 inch
4 inch x 6 inch

DESCRIPTION
Exterior down spout to evacuate waters collected by the eaves trough.

The standard downspouts can be lightly modified and fabricated with copper (16 & 20 oz) or zinc (23 gauge) to match with eaves trough.


Rigid type (anti-vandalism)

The rigid downspouts are fabricated from 3 mm (1/8") thick galvanized steel.

All pieces, anchors and outlets are shop assembled and welded.

Hot galvanized and primer treated, the assembled downspouts are protected by a rustproof paint finish.

The bottom 2400 mm (8') section replaces the standard bottom section on public buildings where shocks or vandalism are frequently experienced.



website created by avatek.ca